|

733 viewsBoth pieces trimmed to length and ready.
|
|

755 viewscheck the fit of the female ring, epoxy in place.
|
|

718 viewsreverse on jam chuck and turn away excess and form the foot. The vessel can be sanded now. After it dries, more hand sanding will be required.
|
|

756 viewsA delicate touch is needed here. Remove all excess leaving just a nub. That will be removed by hand.
|
|

779 viewsso far so good. The male fitting is threaded in to make sure it will thread deep enough.
|
|

785 viewsThe lid piece is chucked up using the tenon that I initially made. A recess is cut for the male threads, and it is epoxied in place.
|
|

796 viewsThe vessel is carefully threaded on to check the fit and profile.
|
|

705 viewsmore shaping on the lid
|
|

700 views
|
|

693 viewsa final look at the profile of lid and vessel together.
|
|

2398 viewsThe lid had been parted off.
|
|

711 viewsUsing another female fitting secured in the chuck, remount the lid and clean up the nub and complete shaping. The lid can be sanded now.
|
|
|