Glacier Woodturners

Woodturning


Last additions - The making of an Urn
new_folder_021.jpg
746 viewsKeep the lid off while drying. The piece will be placed in a plastic bag for several weeks to control the drying. I inspect and air it out daily during this time.Jan 13, 2012
new_folder_016.jpg
702 viewsThe vessel is a slightly different shade because I used sanding sealer on it. None on the lid yetJan 13, 2012
new_folder_015.jpg
806 viewsCompleted. About 70 Cubic inches. An order for a pet urn. Jan 13, 2012
new_folder_011.jpg
2436 viewsJan 13, 2012
new_folder_009.jpg
663 viewsUsing another female fitting secured in the chuck, remount the lid and clean up the nub and complete shaping. The lid can be sanded now.Jan 13, 2012
new_folder_008.jpg
2329 viewsThe lid had been parted off.Jan 13, 2012
new_folder_007.jpg
633 viewsa final look at the profile of lid and vessel together.Jan 13, 2012
new_folder_005.jpg
634 viewsJan 13, 2012
new_folder_004.jpg
629 viewsmore shaping on the lidJan 13, 2012
new_folder_003.jpg
728 viewsThe vessel is carefully threaded on to check the fit and profile.Jan 13, 2012
new_folder_001.jpg
716 viewsThe lid piece is chucked up using the tenon that I initially made. A recess is cut for the male threads, and it is epoxied in place.Jan 13, 2012
Jan_12_032.jpg
710 viewsso far so good. The male fitting is threaded in to make sure it will thread deep enough.Jan 13, 2012
29 files on 3 page(s) 1