 Last additions - The making of an Urn
|

756 viewsA delicate touch is needed here. Remove all excess leaving just a nub. That will be removed by hand.Jan 13, 2012
|
|

718 viewsreverse on jam chuck and turn away excess and form the foot. The vessel can be sanded now. After it dries, more hand sanding will be required.Jan 13, 2012
|
|

755 viewscheck the fit of the female ring, epoxy in place.Jan 13, 2012
|
|

733 viewsBoth pieces trimmed to length and ready.Jan 13, 2012
|
|

769 viewsFemale fitting has been reversed and ready to have excess removed.Jan 13, 2012
|
|

813 viewsExcess has been removed from the male part.Jan 13, 2012
|
|

749 viewsSecure the female fitting in the chuck to hold the male fitting for trimming.Jan 13, 2012
|
|

806 viewsI use common PVC fittings for making my threads.Jan 13, 2012
|
|

820 viewsLazer on tip. Would normally be positioned the wall thickness away from cutter.Jan 13, 2012
|
|

791 viewsLazer showing position of cutting tip.Jan 13, 2012
|
|

843 viewsHollowing system in place.Jan 13, 2012
|
|

749 viewsEven if I have to leave for a few minutes, the piece is covered in plastic to retard drying.Jan 13, 2012
|
|
|