Glacier Woodturners

Woodturning

Last additions
Jan_12_030.jpg
660 viewsA delicate touch is needed here. Remove all excess leaving just a nub. That will be removed by hand.Jan 13, 2012
Jan_12_029.jpg
625 viewsreverse on jam chuck and turn away excess and form the foot. The vessel can be sanded now. After it dries, more hand sanding will be required.Jan 13, 2012
Jan_12_028.jpg
657 viewscheck the fit of the female ring, epoxy in place.Jan 13, 2012
Jan_12_027.jpg
634 viewsBoth pieces trimmed to length and ready.Jan 13, 2012
Jan_12_026.jpg
664 viewsFemale fitting has been reversed and ready to have excess removed.Jan 13, 2012
Jan_12_025.jpg
701 viewsExcess has been removed from the male part.Jan 13, 2012
Jan_12_024.jpg
647 viewsSecure the female fitting in the chuck to hold the male fitting for trimming.Jan 13, 2012
Jan_12_023.jpg
702 viewsI use common PVC fittings for making my threads.Jan 13, 2012
Jan_12_021.jpg
720 viewsLazer on tip. Would normally be positioned the wall thickness away from cutter.Jan 13, 2012
Jan_12_020.jpg
697 viewsLazer showing position of cutting tip.Jan 13, 2012
Jan_12_017.jpg
744 viewsHollowing system in place.Jan 13, 2012
Jan_12_016.jpg
651 viewsEven if I have to leave for a few minutes, the piece is covered in plastic to retard drying.Jan 13, 2012
98 files on 9 page(s) 7