Glacier Woodturners

Woodturning

Last additions - Ian Jeffcock
new_folder_001.jpg
352 viewsThe lid piece is chucked up using the tenon that I initially made. A recess is cut for the male threads, and it is epoxied in place.Jan 13, 2012
Jan_12_032.jpg
356 viewsso far so good. The male fitting is threaded in to make sure it will thread deep enough.Jan 13, 2012
Jan_12_030.jpg
348 viewsA delicate touch is needed here. Remove all excess leaving just a nub. That will be removed by hand.Jan 13, 2012
Jan_12_029.jpg
318 viewsreverse on jam chuck and turn away excess and form the foot. The vessel can be sanded now. After it dries, more hand sanding will be required.Jan 13, 2012
Jan_12_028.jpg
349 viewscheck the fit of the female ring, epoxy in place.Jan 13, 2012
Jan_12_027.jpg
332 viewsBoth pieces trimmed to length and ready.Jan 13, 2012
Jan_12_026.jpg
351 viewsFemale fitting has been reversed and ready to have excess removed.Jan 13, 2012
Jan_12_025.jpg
383 viewsExcess has been removed from the male part.Jan 13, 2012
Jan_12_024.jpg
332 viewsSecure the female fitting in the chuck to hold the male fitting for trimming.Jan 13, 2012
Jan_12_023.jpg
377 viewsI use common PVC fittings for making my threads.Jan 13, 2012
Jan_12_021.jpg
397 viewsLazer on tip. Would normally be positioned the wall thickness away from cutter.Jan 13, 2012
Jan_12_020.jpg
373 viewsLazer showing position of cutting tip.Jan 13, 2012
55 files on 5 page(s) 4