Glacier Woodturners

Woodturning


Most viewed - Ian Jeffcock's Gallery
new_folder_003.jpg
703 viewsThe vessel is carefully threaded on to check the fit and profile.
Jan_12_023.jpg
702 viewsI use common PVC fittings for making my threads.
Jan_12_025.jpg
701 viewsExcess has been removed from the male part.
Jan_12_020.jpg
698 viewsLazer showing position of cutting tip.
new_folder_001.jpg
688 viewsThe lid piece is chucked up using the tenon that I initially made. A recess is cut for the male threads, and it is epoxied in place.
group_of_12inch_bowls_ready_for_drying.jpg
687 viewsstack of cored bowls.
chucked_with_large_jaw_set.jpg
685 views6" jaws on the Vicmarc 120
Jan_12_032.jpg
684 viewsso far so good. The male fitting is threaded in to make sure it will thread deep enough.
large_bowl_blank.jpg
681 views
looking_for_ring_shakes.jpg
677 viewsthis is the center of the log. A bowl blank has been taken from each side. Checking for ring shake, and then I'll cut spindle stock from both sides of the heart wood.
new_folder_016.jpg
676 viewsThe vessel is a slightly different shade because I used sanding sealer on it. None on the lid yet
Jan_12_012.jpg
668 viewsProfile being started. Notice tenon on both ends. Part to the left will either be used as lid or jam chuck later.
55 files on 5 page(s) 3